The Architect's Drawing Board

Specifications for MEMCOline of ADA Signs®

1.01		GENERAL
	A.	The General Document listed in the Index, including the
		General Conditions, Supplementary General Conditions and
		General Requirements are hereby made an integral part of this
		section.
	B.	This subcontractor shall review, in detail, all other sections
		of the construction specifications affecting the work of this
		section of the Specifications.

1.02		REFERENCES
	A.	ANSI A117.1 - 1992 Accessible Signage Standards(4.28 Signage).
	B.	Americans with Disabilities Act Accessibility Guidelines 
		(ADAAG).
        C.      ANSI A117.1 - 1998 Accessible Signage Standards.
        D.      521 CMR Commonwealth of Massachusetts Architectural Access Board.

1.03		QUALITY ASSURANCE
	A.	Fabricator shall have manufactured ADA signage for a minimum
		of four years and have completed work equal to the scope of
		this project.

1.04		SCOPE
	A.	This section includes:
		1.  Interior room signs.
		
1.05		SUBMITTALS
	A.	Submit standard color selection chips.
	B.	Submit manufacturer's product information sheet(s). 
	C.	Submit scaled or full size mock-ups of each sign type.
	D.	Submit one sign of any sign type.
	E.	Submit sign schedule.	
	
2.01		PRODUCTS
	A.	ADA compliant signs where shown on the drawings or otherwise
		indicated shall be manufactured by  MEMCO Merrimack Engraving
		& Marking Co. of Methuen, MA 1-800-726-1719.
	B.	GE Lexan film P/N 8B35, .015" thick with sub-surface printed
		background color(s) bonded to three layers of .040" thick
		GE Lexan.  Background colors are to be chosen from 
		manufacturer's standard color selection. 
	C.	Lettering must be raised 1/32" minimum from the surface of the
		sign.  Edge condition of lettering shall be slightly beveled
		and not square cut.  Lettering colors are to be	chosen from
		manufacturer's standard color selection.
	D.	Grade 2 braille must be embossed to produce domed tops. 
		Grade 2 braille must be an integral part of the sign face and
		not glued or friction fit to the sign face.
	E.	Changeable insert is to be fabricated from GE Lexan film
		P/N 8B35, .010" thick. The insert color is to be the same as
		the sign background.  Lettering will be vinyl.  The color of
		the lettering is to be chosen from the manufacturer's standard
		color selection.
        F.      All sign materials must be resistant to pen ink and permanent markers.

3.01		INSTALLATION
	A.	Signs are to mounted by the manufacturer's recommendations,
		either adhesive backing or tamper proof screws.
	B.	Install signs in accordance with ADAAG guidelines.
	C.	Assure signs are installed level.

		                          END OF SECTION

See our Technical Bulletin explaining the proposed changes to the ADA regarding braille. These proposed changes are nothing new to us, since we have always made our braille to these new requirements.

Return to ADA Signs Specifications Main Page

Send us email at info@memco.net